Comparison of Culture and PCR Methods for Diagnosis of Mycobacterium tuberculosis in Different Clinical Specimens

Background: Tuberculosis remains a global epidemic, especially in developing countries, including Iran. Rapid diagnosis of active Mycobacterium tuberculosis infection plays a critical role in controlling the spread of tuberculosis. Conventional methods may take up to several weeks or longer to produce results. In addition to multiplicity of steps involved in conventional detection, including isolation, identification and drug susceptibility testing, the slow growth rate of M. tuberculosis is also responsible for this lengthy time. Objectives: The aim of this study was to compare the polymerase chain reaction (PCR) and culture methods for the detection of M. tuberculosis in different clinical specimens. Materials and Methods: This study was performed on different samples (urine, gastric aspirate, bronchoalveolar lavage, pleural fluid, cerebrospinal fluid, ascetic fluid and joint fluid specimens) of tuberculosis suspected patients. M. tuberculosis DNA was extracted directly from different samples using two different protocols. Next, PCR was performed using three sets of specific primers to detect members of Mycobacterium genus, M. tuberculosis complex and non-tuberculosis Mycobacteria. The results were then compared with that of the culture method, which is considered as the gold standard method. Results: The concordance rate between the three sets of primers was calculated and IS6110/buffer PCR method showed good agreement with the LJ culture method (κ = 0.627, P < 0.0001). The sensitivity of IS6110/buffer PCR was 58.33%, with specificity of 77.78%; the positive and negative predictive values were 100% and 78.26%, respectively. Buffer method for DNA extraction was proved to give a higher accuracy to PCR in comparison with the boiling method. Conclusions: PCR method is a valuable, cost-effective and alternative tool for quick diagnosis of active tuberculosis in different clinical specimens.


Background
Tuberculosis (TB) represents a global burden and causes significant mortality, mostly in developing countries. It has been suggested that TB was the cause of death in 1.5 million people and infected almost 8.8 million new cases in 2010 (1). Therefore, an early diagnosis of TB is important for prevention of its spread. The gold standard test for diagnosis of TB is through the culture method (2). Culture method is not straightforward because isolation, identification (based on biochemical tests and phenotypic results) and drug susceptibility testing for this bacterium and other Mycobacterial isolates on solid media can take at least four to eight weeks or even longer. Furthermore, the turnaround time of Mycobacterium tuberculosis is high and the method is not always accessible (3). As a result, rapid and easy to perform methods are required to detect and differentiate the Mycobacterium (MYC) genus.
The MYC includes members of M. tuberculosis complex (MTC) and species of non-tuberculosis mycobacteria (NTM). MTC strains are frequently associated with tuberculosis in developing countries while NTM infections are predominantly found in developed countries. Since many members of NTM are resistant to antibiotics used for tuberculosis treatment, rapid and more accurate differential diagnosis of mycobacterial infections is quite important (3,4).
Molecular methods have the potential to detect both M. tuberculosis and non-tuberculous Mycobacteria directly from clinical samples (3). Recently, several PCRbased methods and DNA extraction protocols have been widely used for TB diagnosis in clinical laboratories (5)(6)(7)(8)(9)(10). Although different DNA isolation meth-ods have been developed, including enzymatic lysis using detergents, mechanical disruption, and heat lysis-based methods, few studies have assessed direct treating of crude clinical specimens in order to obtain Mycobacterial DNA without decontamination and/or more purification procedures (11,12). To limit the steps, costs, amount of needed samples, risk of missing Mycobacterial DNA (through procedures prior to DNA isolation) and lower the possibility of cross contamination, we developed a new DNA isolation protocol. In addition, we assessed three different PCR methods using pan-Mycobacterial primers, IS6110 PCR assay and MTC/NTM multiplex PCR primers.
A total of thirty different specimens of TB, from suspected patients referred to Tuberculosis Research Lab at Ghaem University Hospital, were used for this study. The samples underwent Ziehl-Nielsen (ZN) staining, culturing on LJ medium (gold standard) and PCR. DNA was extracted by boiling and buffer methods without more purification steps to save time, amount of samples and the risk of cross contamination.

Objectives
This study was carried out to compare culture and PCR methods for the diagnosis of M. tuberculosis in different clinical specimens using two different DNA extraction protocols.

Bacterial Isolates
Eight Mycobacterial isolates were collected and grown on Lewenstein Jensen (Merck, Germany) slant medium, which then formed clearly visible colonies. Six colonies belonged to M. tuberculosis complex and two were non-tuberculous Mycobacteria strains, which were further confirmed by phenotypic results and the PCR method.

Specimen Preparation
Each sample was used for three procedures, one for decontamination processing and two (1 mL each) for DNA extraction and PCR. Samples were decontaminated, homogenized and cultured on LJ medium by the Petroff technique (13). Two drops from concentrated and homogenized samples were used for indirect smear preparation. Smear preparation, ZN staining and slide reading were carried out according to the recommendations outlined in the Manual of Tuberculosis Bacteriology (14). Samples containing 1 mL body fluid were centrifuged at 1800g for 15 minutes; supernatants were discarded, and pellets were used for DNA isolation.

Isolation of Mycobacterial DNA From Live Mycobacteria and Body Fluids
Two methods for DNA extraction were used. First M. tuberculosis DNA was extracted directly by the tissue digestion protocol. Four hundred microliters of the tissue digestion buffer (Tris-Cl, 100 mM, pH = 7.5; Tween-20, 0.05%) was added to each tube containing either pellets of clinical isolates or colonies. Then, 20 μL of 18.5 mg/mL solution of proteinase K (Fermentas, Germany) was added, agitated, and incubated at 55 o C for 3 hours followed by 10 minutes of heating in boiling water in order to deactivate the action of proteinase K (15). The other protocol for DNA preparation was the simple boiling method. Colonies and pellets from clinical isolates were suspended in 400 µL of distilled water and heated for 10 minutes in a boiling water bath.
The multiplex-touchdown PCR was optimized for efficient amplification of Mycobacterial DNA. The reaction mixtures in a final volume of 20 µL contained 2 µL PCR 10X buffer (Genetbio, South Korea); 1.2 µL MgCl 2 (25 mM Genetbio, South Korea); 0.6 µL of each of 10 pM oligonucleotide primers of MTCF, MTCR, NTMF and NTMR (Metabion International AG, Germany); 0.4 µL of 10 mM dNTPs (Genetbio, South Korea); 0.2 µL of TaqDNA polymerase (Genetbio, South Korea); 11.8 µL of Nuclease free water and 2 µl of extracted DNA. The cycling parameters included an initial denaturation at 95°C for 5 mins; 1 cycle of 1 min at 95°C, 30 seconds at 69°C, and 1 min at 72°C; in subsequent 12 cycles the annealing temperatures were decreased by 1°C every cycle until the temperature reached 57°C; 22 cycles of 1 cycle of 1 min at 95°C, 30 seconds at 56°C, and 1 min at 72°C; followed by an additional cycle of 10 mins at 72°C. The IS6110-PCR assay was derived from the study of Espasa et al (12).

Detection of Amplified DNA
The amplified DNA products were visualized by UV illumination after agarose gel electrophoresis and green viewer staining.

Statistical Analysis
Laboratory data were analyzed by the SPSS v.20 software (SPSS Inc., Chicago, IL, USA). Sensitivity, specificity and accuracy of the PCR method were compared with that of the culture method.

Results
Out of thirty different clinical samples, 12 were positive by the culture method and 18 showed negative results. We used four sets of primers. A product of around 350-500 bp was obtained for the detection of MYC and products of around 235 bp and 136 bp were obtained from MTC and NTM strains, respectively. For detecting IS6110 insertion sequence, a product of around 150 bp was observed (Figure 1).

Discussion
Rapid identification of Mycobacterial infections is critical in clinical management of various diseases. It would determine the proper time for administration of antibiotics, the most suitable antibiotic, contact precautions and prophylaxis (4,16,17). Conventional diagnostic methods for detection of Mycobacterial infections are smear microscopy with ZN staining and culturing on LJ medium (4,18). Despite the fact that microscopic smear examination is low-cost, rapid and easy to perform, it suffers from poor sensitivity and lack of distinctive specific-ity (19). Bacilloscopy normally requires more than one sample and does not differentiate the Mycobacterial genus. Culture is the gold standard test for diagnosis of TB. It has high specificity and its sensitivity is considered to be about 100 folds more than that of smear microscopy. The disadvantage of the culture method is its prolonged hands-on time and the need for gold standard laboratory infrastructure, which is limited to reference centers (18).
PCR-based assays have been used to detect Mycobacterial DNA with high sensitivity and specificity (3-9, 11, 12, 16, 19-21). In this study, we compared smear microscopy with three PCR-based methods using two different DNA extraction protocols. Culture method was regarded as the gold standard of TB diagnosis.
Results showed that, bacilloscopy followed by homogenization and concentration by the Petroff technique showed 75% sensitivity and 83.33% specificity. Several studies showed similar results to our study (21)(22)(23). However, some studies reported a lower sensitivity of about 20% to 50% (20,21,24). In fact, the procedures used for bacilloscopy by such studies, were all rather indirect smear microscopy tests and the variety in their sensitivity may have been due to common laboratory errors. Lima et al. compared smear microscopy with the LJ culture method and found a kappa coefficient of 0.62, which was almost the same as that found by our study (0.583) (23). We did not find NTM species among the specimens of our study. A reason for this observation could be the limited number of samples recruited in this study. Several studies have reported variable results regarding TB-PCR.
Prakash et al. performed IS6110-PCR on purified DNA and reported sensitivity and specificity of 57% and 100%, respectively (25). In our study, the sensitivity of IS6110-buffer PCR on crude DNA was slightly higher (58.33%), however, the specificity was similar (100%). It may suggest that direct isolation of DNA by digestion buffer could be a valuable method to prevent the loss of bacterial DNA as opposed to the chloroform-phenol-isoamyl alcohol extraction method (25).
Use of commercial PCR kits on purified DNA before and after five days of brief-culture on LJ media resulted a sensitivity of 27.8% and 62.5%, respectively (26). It is expected that brief culturing, as part of the method proposed in this study, could increase the sensitivity of the test. Gupta et al. showed an overall sensitivity and specificity of 91.5% and 86%, respectively, for IS6110-PCR assay on purified DNA (27). In a study by Park et al. sensitivity and specificity of IS6110-Nested PCR on phenol-chloroform extracted DNA were reported to be 85% and 99%, respectively (28). An explanation for this observation could be the larger sample size (27) and also different PCR strategies (28).
Another report showed a PCR sensitivity of 85.7% and a specificity of 60% for diagnosis of M. tuberculosis in culture (22). Overall, our data showed that the buffer method is more efficient for direct DNA isolation compared with that of the boiling method. In the present study, pan-Mycobacterial/buffer PCR showed moderate to good sensitivity (66.67%) and specificity (77.78%). Kappa coefficient from comparison of PCR methods versus LJ culture showed a good agreement with IS6110/buffer PCR. It was also shown that IS6110/buffer PCR has the highest accuracy amongst PCR methods already discussed. Although PCR is a sensitive, specific, quick, straightforward and minimally invasive method for detection of M. tuberculosis in clinical samples, contamination of specimens with mycobacterial DNA from previous PCRs and/or contamination of samples during DNA isolation procedures may be the source of false positive results.
This study compared conventional techniques and several PCR methods for diagnosis of tuberculosis. Since the sample size was too small, further studies are necessary to confirm, evaluate and improve the sensitivity, specificity and accuracy of the currently available tests. In conclusion, this study discussed a method, which is able to detect M. tuberculosis rapidly and directly in clinical samples. IS6110 PCR method might become a valuable, cost-effective and alternative tool for quick diagnosis of tuberculosis.